Page 10

- 10 -

www.ubicom.com

SX20AC/SX28AC

PLP_A, PLP_B, and PLP_C: Pullup Enable Registers

(MODE=0Eh)
Each register bit determines whether an internal pullup

resistor is connected to the pin. Set the bit to 1 to discon-

nect the pullup resistor or clear the bit to 0 to connect the

pullup resistor.
LVL_A, LVL_B, and LVL_C: Input Level Registers

(MODE=0Dh)
Each register bit determines the voltage levels sensed on

the input port, either TTL or CMOS, when the Schmitt

trigger option is disabled. Program each bit according to

the type of device that is driving the port input pin. Set the

bit to 1 for TTL or clear the bit to 0 for CMOS.
ST_B and ST_C: Schmitt Trigger Enable Registers

(MODE=0Ch)
Each register bit determines whether the port input pin

operates with a Schmitt trigger. Set the bit to 1 to disable

Schmitt trigger operation and sense either TTL or CMOS

voltage levels; or clear the bit to 0 to enable Schmitt trig-

ger operation.
WKEN_B: Wakeup Enable Register (MODE=0Bh)
Each register bit enables or disables the Multi-Input

Wakeup/Interrupt (MIWU) function for the corresponding

Port B input pin. Clear the bit to 0 to enable MIWU opera-

tion or set the bit to 1 to disable MIWU operation. For

more information on using the Multi-Input Wakeup/Inter-

rupt function, see Section 7.0.
WKED_B: Wakeup Edge Register (MODE=0Ah)
Each register bit selects the edge sensitivity of the Port B

input pin for MIWU operation. Clear the bit to 0 to sense

rising (low-to-high) edges. Set the bit to 1 to sense falling

(high-to-low) edges.

WKPND_B: Wakeup Pending Bit Register

(MODE=09h)
When you access the WKPND_B register using MOV

!RB,W, the CPU does an exchange between the contents

of W and WKPND_B. This feature lets you read the

WKPND_B register contents. Each bit indicates the sta-

tus of the corresponding MIWU pin. A bit set to 1 indi-

cates that a valid edge has occurred on the

corresponding MIWU pin, triggering a wakeup or inter-

rupt. A bit set to 0 indicates that no valid edge has

occurred on the MIWU pin.
CMP_B: Comparator Register (MODE=08h)
When you access the CMP_B register using MOV

!RB,W, the CPU does an exchange between the contents

of W and CMP_B. This feature lets you read the CMP_B

comparator. Clear bit 6 to place the comparator result on

the RB0 pin. Bit 0 is a result bit that is set to 1 when the

voltage on RB2 is greater than RB1, or cleared to 0 oth-

erwise. (For more information using the comparator, see

Section 11.0.)
3.2.3 Port Configuration Upon Reset
Upon reset, all the port direction registers are initialized

to FFh (except WKPND_B and CMP_B -- see

Table 14-1). Thus, each pin is configured to operate as a

high-impedance input that senses TTL voltage levels,

with no internal pullup resistor connected. The MODE

access to the data direction registers using the "MOV

!rx,W" instruction.