Twinax Setup Menu
Use the Twinax Setup Menu to configure the twinax interface. The following
table describes the settings you can change from the Twinax Setup Menu. An
asterisk (*) next to a value in the table indicates the factory default. The
Twinax Setup Menu appears only if you have the twinax network interface
card installed.
Notes:
1. To select a new value, press the Enter key when the value is displayed in
the message display area. An asterisk (*) appears next to the value in the
message display area, indicating that it is now active.
2. For more information about configuring the twinax interface, see
Twinax/Coax Configuration Guide.
3. If you are unfamiliar with using the operator panel to work with menus,
please read “Using the Operator Panel Keys” on page 22 and “Navigating
Menus” on page 23 before continuing.
Twinax Setup
Menu Item
Value
Description
SCS ADDR
OFF*
n
The twinax hardware address of the SCS port. n can be
from 0 to 6.
Notes:
1. SCS ADDR and IPDS ADDR cannot be set to the same
value.
2. When the IBM AFP/IPDS Module is installed, the
printer can act as two separate printers on the same
twinax port. (The printer cannot be attached to two
different twinax systems using the same twinax card.)
One “printer” prints SCS data to one address (SCS
ADDR), and the other prints IPDS to another address
(IPDS ADDR).
IPDS ADDR
OFF*
n
The twinax hardware address of the IPDS port. n can be
from 0 to 6.
Notes:
1. SCS ADDR and IPDS ADDR cannot be set to the same
value.
2. When the IBM AFP/IPDS Module is installed, the
printer can act as two separate printers on the same
twinax port. (The printer cannot be attached to two
different twinax systems using the same twinax card.)
One “printer” prints SCS data to one address (SCS
ADDR), and the other prints IPDS to another address
(IPDS ADDR).
Chapter 6. Operator Panel Menus
121
