Network Menu
Important!
For information about configuring Ethernet or token-ring interfaces,
please see Ethernet and Token Ring Configuration Guide, which comes with
the Ethernet and token-ring network interface cards. “Chapter 9.
Configuring Printer Network Addresses” on page 185 describes how to
define the IP address, default gateway address, and subnet mask from
the operator panel.
Use the Network Menu to configure network settings. The following table
describes the settings you can change from the Network Menu. An asterisk (*)
next to a value in the table indicates the factory default. The Network Menu
appears only if you have the token-ring or Ethernet interface installed.
Notes:
1. To select a new value, press the Enter key when the value is displayed in
the message display area. An asterisk (*) appears next to the value in the
message display area, indicating that is now active.
2. If you are unfamiliar with using the operator panel to work with menus,
please read “Using the Operator Panel Keys” on page 22 and “Navigating
Menus” on page 23 before continuing.
Network Menu
Item
Value
Description
TCP/IP
ON
This value cannot be changed. TCP/IP communications are
always ON.
NETWARE
ON*
OFF
Turns NetWare communications on or off.
v ON—enables NetWare communications.
v OFF—disables NetWare communications.
NETBIOS
ON*
OFF
Turns NetBIOS communications on or off.
v ON—enables NetBIOS communications.
v OFF—disables NetBIOS communications.
APPLETALK
ON*
OFF
Turns AppleTalk communications on or off.
v ON—enables AppleTalk communications.
v OFF—disables AppleTalk communications.
102 Infoprint 21: User’s Guide
