© 1999 Scenix Semiconductor, Inc. All rights reserved. - 16 - www.scenix.com SX18AC  / SX20AC / SX28AC 7.0 POWER DOWN MODE The   power   down   mode   is   entered   by   executing   the
SLEEP instruction.
In power down mode, only the Watchdog Timer (WDT) is
active. If the Watchdog Timer is enabled, upon execution
of the SLEEP instruction, the Watchdog Timer is cleared,
the TO (time out) bit is set in the STATUS register, and
the PD (power down) bit is cleared in the STATUS regis-
ter.
There  are  three  different  ways  to  exit  from  the  power
down mode: a timer overflow signal from the Watchdog
Timer (WDT), a valid transition on any of the Multi-Input
Wakeup pins (Port B pins), or through an external reset
input on the MCLR pin.
To achieve the lowest possible power consumption, the
Watchdog   Timer   should   be   disabled   and   the   device
should exit the power down mode through the Multi-Input
Wakeup (MIWU) pins or an external reset. 7.1 Multi-Input Wakeup Multi-Input Wakeup is one way of causing the device to
exit the power down mode. Port B is used to support this feature.  The  WKEN_B  register  (Wakeup  Enable  Regis-
ter) allows any Port B pin or combination of pins to cause
the   wakeup.   Clearing   a   bit   in   the   WKEN_B   register
enables the wakeup on the corresponding Port B pin. If
multi-input  wakeup  is  selected  to  cause  a  wakeup,  the
trigger condition on the selected pin can be either rising
edge  (low  to  high)  or  falling  edge  (high  to  low).  The
WKED_B   register   (Wakeup   Edge   Select)   selects   the
desired transition edge. Setting a bit in the WKED_B reg-
ister selects the falling edge on the corresponding Port B.
Clearing  the  bit  selects  the  rising  edge.  The  WKEN_B
and WKED_B registers are set to FFh upon reset.
Once  a  valid  transition  occurs  on  the  selected  pin,  the
WKPND_B  register  (Wakeup  Pending  Register)  latches
the transition in the corresponding bit position. A logic ‘1’
indicates the occurrence of the selected trigger edge on
the corresponding Port B pin.
Upon   exiting   the   power   down   mode,   the   Multi-Input
Wakeup logic causes program counter to branch to the
maximum program memory address (same as reset).
Figure 7-1 shows the Multi-Input Wakeup block diagram. Figure  7-1. Multi-Input Wakeup Block Diagram W MODE Wake-up : Exit Power Down 8 8 RB7 RB6 RB1 RB0 WKED_B WKPND_B WKEN_B MODE = 09 Port B
Configured
as Input 0 1 8 0 = Enable
1 = Disable