© 1999 Scenix Semiconductor, Inc. All rights reserved. - 1 - www.scenix.com Scenix™ and the Scenix logo are trademarks of Scenix Semiconductor, Inc.
I²C™ is a trademark of Philips Corporation
PIC® is a registered trademark of Microchip Technology, Inc.
Microchip® is a registered trademark of Microchip Technology, Inc. SX-Key™ is a trademark of Parallax, Inc.
Microwire™ is a trademark of National Semiconductor Corporation
All other trademarks mentioned in this document are property of their respec-
tive companies. PRELIMINARY May 30, 1999 Devices with Datcode Axyywwxx SX18AC / SX20AC / SX28AC High-Performance 8-Bit Microcontrollers with EE/Flash Program
Memory and In-System Programming Capability 1.0 PRODUCT OVERVIEW 1.1 Introduction The  SX18AC,  SX20AC,  and  SX28AC  are  members  of
the SX family of high-performance 8-bit microcontrollers
fabricated  in  an  advanced  CMOS  process  technology.
The  advanced  process,  combined  with  a  RISC-based
architecture, allows high-speed computation, flexible I/O
control,  and  efficient  data  manipulation.  Throughput  is
enhanced by operating the device at frequencies up to 50
MHz  and  by  optimizing  the  instruction  set  to  include
mostly single-cycle instructions.
On-chip  functions  include  a  general-purpose  8-bit  timer
with prescaler, an analog comparator, a brown-out detec-
tor,  a  watchdog  timer,  a  power-save  mode  with  multi-
source   wakeup   capability,   an   internal   R/C   oscillator,
user-selectable clock modes, and high-current outputs. 1.2 Key Features •    50 MIPS performance at 50 MHz oscillator frequency
•    2048 x 12 bits EE/Flash program memory rated for       10,000 rewrite cycles
•    136 x 8 bits SRAM
•    In-system programming capability through OSC pins
•    Internal RC oscillator with configurable rate from 31.25       KHz to 4 MHz, +8% accuracy
•    User selectable clock modes: –   Internal RC oscillator
–   External oscillator
–   Crystal/resonator options
–   External RC oscillator (continued on page 3) Figure  1-1. Block Diagram Interrupt MIWU Port B Comp Power-On Reset RESET 8-bit Watchdog Timer (WDT) 8-bit Timer RTCC 8 8 8 Port C 8 8 Port A 8 4 Internal Data Bus  In-System
Debugging     In-System
Programming    2k x 12
EEPROM System Clock Brown-Out MIWU MCLR  OSC
Driver
4MHz  Internal
RC OSC  Clock
Select ¸ 4 or ¸ 1 136 Bytes SRAM Address Write Data Read Data Instruction W FSR STATUS PC MODE OPTION System Clock OSC1   OSC2 Fetch 8 8 12 Address 12 8 8 8 8 ALU 8 8 8 3 RTCC Analog 8 or Interrupt Stack     PC
3 Level Decode Executive Write Back IREAD Stack Prescaler for RTCC Prescaler for WDT Instruction Pipeline