COAX SETUP MENU ITEM VALUE Description EDGE-EDGE OFF*
ON Turns edge-to-edge printing on or off. Ÿ   OFF—the printer maintains a border of 4 mm on all four       paper sides.
Ÿ   ON—The printer allows printing up to the physical page size. Notes: 1.  To prevent toner from contaminating the printer, IBM recommends leaving EDGE-EDGE set to OFF; use ON only
when necessary. 2.  The Coax Setup Menu item EDGE-EDGE applies to SCS data only.   To specify edge-to-edge printing for IPDS data,
use the EDGE-EDGE item on the IPDS Menu. EAB DISABLE*
ENABLE Enables or disables the extended attribute buffer. BUFFERSIZE 960
1920*
2560
3440
3564 Specifies the buffer size in bytes. EARLY COMPL ON*
OFF Turns early print completion on or off for non-IPDS data sent over
the coax attachment.   To turn early print completion on or off for
IPDS data, use the EARLY COMPL item on the IPDS Menu. Ÿ   ON—sends an “order complete” as soon as data is received.
Ÿ   OFF—waits until the print job is physically complete to send “order complete.” PA1 none Selecting this value and pressing the Continue/Enter key sends
a PA1 signal to the host. Note:   This applies to SCS only; not DSC/DSE or IPDS. PA2 none Selecting this value and pressing the Continue/Enter key sends
a PA2 signal to the host. Note:   This applies to SCS only; not DSC/DSE or IPDS. Chapter 5.   Operator Panel Menus 79