IPDS MENU ITEM VALUE Description EDGE-EDGE OFF*
ON Turns edge-to-edge printing on or off. Ÿ   OFF—the printer maintains a no-print border of 4 mm on all four       paper sides.
Ÿ   ON—The printer allows printing up to the physical page size. Notes: 1.  To prevent toner from contaminating the printer, IBM recommends leaving EDGE-EDGE set to OFF; use ON only when necessary. 2.  The IPDS Menu item EDGE-EDGE applies to IPDS data only.   To specify edge-to-edge printing for non-IPDS data sent over the coax
attachment, use the EDGE-EDGE item on the Coax Setup Menu.   To
specify edge-to-edge printing for non-IPDS data sent over the twinax
attachment, use the EDGE-EDGE item on the Twinax Setup Menu. FONT SUB OFF*
ON Turns font substitution on or off. Ÿ   OFF—if a job requests a font that is not loaded on the printer, the port       generates an IPDS NACK message and the host holds the job.
Ÿ   ON—if a job requests a font that is not loaded on the printer, the printer attempts to substitute another font. IPDS PORT COAX*
TX
TRING
ETHER Specifies the attachment you use for IPDS jobs. Note:   You can print IPDS from more than one port; setting this item,
therefore, does not restrict you from printing from multiple ports.   Also, this
item may not appear on some printers. EARLY COMPL OFF*
ON Turns early print completion on or off for IPDS jobs. Ÿ   OFF—the printer waits until the job is physically complete to signal the       host that the job is complete.
Ÿ   ON—the printer signals the host that the job is complete as soon as the IPDS data is formatted. Setting EARLY COMPL=ON may improve print performance, but may also
degrade recovery and cause lost data for some printing problems, such as
jams. 88 User’s Guide