Coaxial Setup Menu Item Value Description BUSY TMEOUT nnn
OFF Specifies the busy timeout value. This specifies the amount
of time to wait (when the printer is connected to multiple
ports) for control to be returned to the coax interface, before
notifying the host. nnn can be from 1 to 999 minutes. The
default is 20 minutes. OFF specifies to never send a busy
timeout. EDGE-EDGE OFF*
ON Turns edge-to-edge printing on or off.
v  OFF—the printer maintains a border of 4 mm (0.156 in)     on all four paper sides.
v  ON—The printer allows printing up to the physical page size. Notes:
1.   To prevent toner from contaminating the printer, IBM       recommends leaving EDGE-EDGE set to OFF for coax
      printing; use ON only when necessary.
2.   The Coaxial Setup Menu item EDGE-EDGE applies to SCS data only. To specify edge-to-edge printing for IPDS
data, use the EDGE-EDGE item on the IPDS Menu. EAB ON*
OFF Enables or disables the extended attribute buffer support. Notes:
1.   The EAB menu item also enables or disables the ability       to print IPDS jobs over the coax interface.
2.   If you change EAB, you must power off the printer, wait ten seconds, and then power on the printer for the new
value to take effect. BUFFERSIZE 960
1920*
2560
3440
3564 Specifies the buffer size in bytes.
Note:  If you change BUFFERSIZE, you must power off the
printer, wait ten seconds, and then power on the printer for
the new value to take effect. EARLY COMPL ON*
OFF Turns early print completion on or off for non-IPDS data
sent over the coax interface.
v  ON—sends an “order complete” as soon as data is     received.
v  OFF—waits until the print job is physically complete to send “order complete.” TBM nn.n The top binding margin (TBM) determines the position of
line 1 relative to the top edge of the printable area when
printing in portrait or landscape orientation. TBM is
measured in tenths of an inch, with a default of 0. It applies
to all paper sources. Chapter 6. Operator Panel Menus 119