ON 20050801@11:49:15 PM at page:
http://piclist.org/techref/piclist/questions.htm#38565.9925347222
[d_gujarathi2000-yahoo-] Questions:
MPLAB: No target error.
Hi Listers,
I am facing problems with MPLAB IDE and my Debugger h/w.
Heres the problem.
I have a MPLAB IDE v5.70 (fw ver. 2.30.01) connected to a ICD h/w connected to a Target board (16F877 chip). This set up of mine was working since past 6 months withouit any issues. But suddenly I cannot use the h/w.
I am able to connect to the ICD board successfully, but whenever I try to Program/Erase/Read/Verify I get a "No target" error. I have tried to replace the PIC 16F877 chip on the target board with a new one, but the problem still persists. Strangely the self test is successful.
What could be going wrong ? any pointers appreciated
thanks for your patience.
Deepesh
ON 20050805 at page:
http://www.massmind.org/techref/piclist/pcbcontest.htm
someone[--] edited the page. Difference:
"R:\bak\H\techref\piclist\pcbcontest.htm.20050805.dif"
ON 20050806@3:47:47 AM at page:
http://piclist.com/techref/piclist/questions.htm#38570.1581828704
Sajid Naqvi[SN-WPC-C41] Says
Hi,
I am making a 300VAC voltmeter on PIC. I need circuit diagram for linear conversion from 0-300VAC to 0-5.00VDC FSD. Both the supplies are to be isolated. Optocoupler based circuit would be great.
Thanks
ON 20050807@12:31:17 PM at page:
http://www.piclist.com/techref/piclist/support.htm#38551.8645023148
James Newton[JMN-EFP-786] removed post 38551.8645023148
|Delete 'Roland H. Wills of WEMMCO Says: