ON 20060216@10:12:44 AM at page: http://www.piclist.com/language/pcl/index.htm#38764.3384490741 James Newton[JMN-EFP-786] Published and replied to post 38764.3384490741 |Insert 'When you say "change this" do you mean that you are now sending the &s1C after the page size? Or that you removed the &s1C? In any case, it sounds like the &s1C was interferring with the page size, and that is, very certainly, something that is not documented and quite interesting.' at: '' Hi, I have a problem. I'm sending an A3 pcl print job to the machine, the selected tray is out of paper, then the device shows the default paper size is missing ( set the default to 8 1/2 X 11 it shows this size ) but it should show A3 paper is missing. I figured out that in the pcl stream the Esc&s1C command is send before the page size Esc&l27A. If I change this all is fine. But the PCL Reference don't specified to send this command in an order. Thanks in advance. |Delete 'P-' before: '' but after: 'mike@ndc.com asks:
HI, I am working with an embedded cpu using 'C'. We currently have an HP Paint Jet and a HP Desk Jet that both print in color well. I now have a HP Laser Jet 2550 and I cannot get it to print in color. It looks like it is using planes but always prints in black. What command(s) am I missing? Also, I am using 4 planes. Is that correct?|Delete 'P-' before: '' but after: ' Hi,This belongs to the &s1C problem. Thanks for the answer. To answer your question : It doesn't matter if I remove this command or if I set the size command before the &s1C command. In both cases it shows the required page size is missing. If I set SubPageSize to Auto on the device itself, than the device shows the correct page size is missing, even if the &s1C command is send before the &l27A command. Can someone test this on a HP printer? Best regards Joerg |Delete 'P-' before: '' but after: ' I need to create a landscape font to support 148 characters for a Payer RA report.