ON 20090212@1:39:33 PM at page:
http://www.piclist.org/techref/io/stepper/linistep/index.htm#39856.5691203704
anas malek ghhj[amg-aaa-] See:
/techref/microchip/io/audio.htm
PIC Microcontoller Audio Input / Output 



ON 20090220@12:07:11 PM at page:
http://techref.massmind.org/techref/io/stepper/linistep/lini_use.htm#38838.4632523148
James Newton[JMN-EFP-786] Published and replied to post 38838.4632523148

|Insert 'Start in full step mode and make sure you have the motor leads connected correctly. Once that is working, then move up to half and then the micro-stepping modes.' at: '<!-- 38838.4632523148 EOR -->'

<A TITLE="P-146.184.0.119" NAME="38838.4632523148"> </A> Hi, nice little
    board! I have a small stepper, not sure of the specs, but the power supply
    is set for 10V and is drawing about 0.3 amps. The motor is above room temp
    and the heatsink is hard to tell if it is above room temp. I am trying to
    get slow smooth steps and have m1 and m0 high. I am feeding 18 Hz and the
    motor looks like it does two steps and then waits a half second then two
    more steps. There might be some smaller steps in with the two steps, but
    there is definatly a half second with no motion. Do I need to put larger
    caps in for c5 and c6 to get 3600 even spaced in time
    steps?
|Delete 'P-' before: '<!-- 38838.4632523148 EOR -->' but after: '<A TITLE="'.