ON 20071101@12:57:12 PM at page: http://massmind.org/techref/io/stepper/linistep/index.htm# David A Cary[DAV-MP-E62a] edited the page. Difference: http://massmind.org/techref/diff.asp?url=H:\techref\io\stepper\linistep\index.htm&version=41 ON 20071112@6:17:35 PM at page: http://www.piclist.com/io/stepper/linistep/index.htm#39398.759375 James Newton[JMN-EFP-786] removed post 39398.759375 |Delete 'dhaykus0418@wowway.com asks:

Given correct resistor values and heatsinking should I reasonably expect to drive a motor of these specs: "305oz-in unipolar rating, 4.2v, 3A, 200 S/R 3.2mH, Size #23, Dual Shaft, 8 wire" from hobbycnc.com? Thanks. Any comments welcome.

' ON 20071119@4:08:32 PM at page: http://www.piclist.com/io/stepper/linistep/index.htm#39404.6176157407 James Newton[JMN-EFP-786] removed post 39404.6176157407 with comment: 'All the code we have is right there on the site... The lini is an open source project.' |Delete 'staqi3@gmail.com asks:

Hi how are you, just saw this website, i am building a code and microcontroler circuit using pic18f4455, and the motor i want to run with this pic chip has chracteristics, 4.7A/1.7V 1.8DEG per step, i made some code but whenever try to run my pic restart, i was just woundering if you guys can help me out by building the circuit with some code, if you can then i can provide the details and offcourse you can tell me later how much will it cost. please do reply me
Raza
3202375345

' ON 20071119@4:09:10 PM at page: http://www.piclist.com/techref/io/stepper/linistep/index.htm#39367.2247337963 James Newton[JMN-EFP-786] removed post 39367.2247337963 with comment: 'That would be jamesnewton@geocities.com' |Delete 'superarn@gmail.com

hi - who do i email to find out all the bits and pieces i need to order to get started (i'm in South Africa here) would have to import - any reply would be appreciated!