ON 20050715@11:09:25 AM at page:
http://www.piclist.com/io/stepper/linistep/index.htm#38546.9522916667
James Newton[JMN-EFP-786] Published and replied to post 38546.9522916667 by chris_kee

|Insert 'You can use all or only one resistor in those places to adjust the resistance and fine tune the operation of the controller. See the page on <A HREF="lini_tun.htm">tuning the linistepper</A> for details.' at: '<!-- 38546.9522916667 EOR -->'

<A TITLE="P-219.93.31.30" NAME="38546.9522916667" HREF="mailto:chris_kee@celcom.net.my">chris_kee@celcom.net.my</A> asks: <BLOCKQUOTE><A NAME="219.93.31.30">
</A> 
Hi,<BR>
From the schemetic diagram, I found out there are resistors connected in series: R18 with R19, R20 with R21, etc.  In actual board layout, I saw only one resistor being soldered, ie R18/R19 = 150 ohms. Could you please advice? I am confused. Is 150 ohms equal to two resistors in series? Or can I substitute the pair resistors with one resistor only?<BR>
<BR>
Thank you.<BR>
<BR>
Rgds,<BR>
Chris<BR>
</BLOCKQUOTE>

|Delete 'P-' before: '<!-- 38546.9522916667 EOR -->' but after: '<A TITLE="'.