ON 20041202@11:52:26 AM at page:
http://www.piclist.com/io/lcd/LPH7366.htm#38323.1586458333
James Newton[JMN-EFP-786] published post 38323.1586458333

<A TITLE="P-193.191.136.65" NAME="38323.1586458333">
</A> 
Got an old 3210 lcd...<BR>
The contacts are made from rubber...etched a pcb and got good contacts...but the lcd just doesn't show anything...thought it was a problem from my code...just used yours...didn't work...<BR>
the lcd just seem not to reset at startup...<BR>
used a circuit laid in a magasine here in belgium...the lcd starts up (resets...) but shows a black line per banks (every eight lines) in the place of the beautifull images it should display...<BR>
i've read the datasheets...everything should be correct...nothing is correct...<BR>
<BR>
Is there any tricks i miss...about the data transmitions to the lcd? (do we have to care about the signal times up and down during a sclk cycle...what is the rate at which data are sent to the lcd (used a 6ms wait cycle :should be an average 80Hz cycle ...)...<BR>

|Delete 'P-' before: '<!-- 38323.1586458333 EOR -->' but after: '<A TITLE="'.



ON 20041202@10:30:59 PM at page:
http://www.piclist.com/io/lcd/LPH7366.htm#38323.1586458333
Bergthaller C Iulian[BCI-hotmail-K96] Replied to post 38323.1586458333

|Insert 'Try to connect a 1uF capacitor from Vlcd to ground! Check the rubber contacts too.' at: '<!-- 38323.1586458333 EOR -->'

<A TITLE="193.191.136.65" NAME="38323.1586458333">
</A> 
Got an old 3210 lcd...<BR>
The contacts are made from rubber...etched a pcb and got good contacts...but the lcd just doesn't show anything...thought it was a problem from my code...just used yours...didn't work...<BR>
the lcd just seem not to reset at startup...<BR>
used a circuit laid in a magasine here in belgium...the lcd starts up (resets...) but shows a black line per banks (every eight lines) in the place of the beautifull images it should display...<BR>
i've read the datasheets...everything should be correct...nothing is correct...<BR>
<BR>
Is there any tricks i miss...about the data transmitions to the lcd? (do we have to care about the signal times up and down during a sclk cycle...what is the rate at which data are sent to the lcd (used a 6ms wait cycle :should be an average 80Hz cycle ...)...<BR>