Art,

This should do what you need

https://www.mouser.com/new/tempflex/tempflex_microminiature/


> On Nov 22, 2018, at 7:12 PM, Art <ky1k@myfairpoint.net> wrote:
>=20
> Hi All,
>=20
> I'm nearing the end of the PCB design phase for my PIC project, and now
> I need to consider how to interface it with the outside world. It will
> be located in an extremely high rf environment, so shielded cable will
> be needed.
>=20
> I'm looking for ultra-miniature shielded cable. In the past, I've used
> Shielded IDE cables....which only provided partial shielding. The
> salvaged IDE cables have a built in very fine copper mesh on one side of
> the cable.
>=20
> I need something with better shielding. It must be small diameter and
> somewhat flexible.....RG174 type coax is far to large.
>=20
> I've seen sub-micro sized coax in scraped wireless routers and similar
> products, but never saw (or found a source for) it available for
> purchase. The cable will not need to conduct rf, but it will need to
> shield against rf entry into my project and it needs to be somewhat
> flexible. It will carry very low currents and voltages (PIC I/O limited
> to 3 volts max).
>=20
> I need about 12 feet in 3 pieces. Two conductor shielded cable is ok as
> well.
>=20
> This is for a prototype, so I can get by with sacrificed durability
> initially.
>=20
> Any ideas?
>=20
> TY
>=20
> Art
>=20
>=20
> --=20
> http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist

Just my $0.02,

Jean-Paul
N1JPL



--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.