Use VeroBoard and cut the strips with a razor saw. On Thu, 22 Nov 2018 at 11:19, David C Brown wrote: > There is usually a limit on the number of holes you can have on a prototy= pe > board. Drilling is quite an expensive process for the manufacturer > __________________________________________ > David C Brown > 43 Bings Road > Whaley Bridge > High Peak Phone: 01663 733236 > Derbyshire eMail: dcb.home@gmail.com > SK23 7ND web: www.bings-knowle.co.uk/dcb > > > > > *Sent from my etch-a-sketch* > > > On Thu, 22 Nov 2018 at 00:20, Jason White < > whitewaterssoftwareinfo@gmail.com> > wrote: > > > Worst case scenario you could have some made by a prototype PCB > > manufacturer. (typically costs less than $10 USD for 10, 4x4" boards) > > > > On Wednesday, November 21, 2018, David C Brown > wrote: > > > > > Does any body know of a source, preferably European, for tripad > > > stripboard.? I have a nast suspicion that it is no longer made. Whi= ch > > is > > > a pity. > > > __________________________________________ > > > David C Brown > > > 43 Bings Road > > > Whaley Bridge > > > High Peak Phone: 01663 733236 > > > Derbyshire eMail: dcb.home@gmail.com > > > SK23 7ND web: www.bings-knowle.co.uk/dcb > > > > > > > > > > > > > > > *Sent from my etch-a-sketch* > > > -- > > > http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive > > > View/change your membership options at > > > http://mailman.mit.edu/mailman/listinfo/piclist > > > > > > > > > -- > > Jason White > > -- > > http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive > > View/change your membership options at > > http://mailman.mit.edu/mailman/listinfo/piclist > > > -- > http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist > --=20 http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .