There is usually a limit on the number of holes you can have on a prototype board. Drilling is quite an expensive process for the manufacturer __________________________________________ David C Brown 43 Bings Road Whaley Bridge High Peak Phone: 01663 733236 Derbyshire eMail: dcb.home@gmail.com SK23 7ND web: www.bings-knowle.co.uk/dcb *Sent from my etch-a-sketch* On Thu, 22 Nov 2018 at 00:20, Jason White wrote: > Worst case scenario you could have some made by a prototype PCB > manufacturer. (typically costs less than $10 USD for 10, 4x4" boards) > > On Wednesday, November 21, 2018, David C Brown wrote= : > > > Does any body know of a source, preferably European, for tripad > > stripboard.? I have a nast suspicion that it is no longer made. Which > is > > a pity. > > __________________________________________ > > David C Brown > > 43 Bings Road > > Whaley Bridge > > High Peak Phone: 01663 733236 > > Derbyshire eMail: dcb.home@gmail.com > > SK23 7ND web: www.bings-knowle.co.uk/dcb > > > > > > > > > > *Sent from my etch-a-sketch* > > -- > > http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive > > View/change your membership options at > > http://mailman.mit.edu/mailman/listinfo/piclist > > > > > -- > Jason White > -- > http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist > --=20 http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .