Hi,

Is there a way to get MPLAB X to run an .exe program *after* the device is
programmed, in the same way that it can run a program before the build (or
after the build) ?

I've made a device that switches the PGMD/PGMC lines, so they can be shared=
,
so it needs to be told to switch to the ICD4 for programming and then back
to the stuff on the PCB for testing.

If I can't figure anything else I can put a long delay in the device firmwa=
re
to do the switching, but it would be nice to have it go back right after th=
e
programming operating completes.

Thanks!

--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.