Well, that sent me off down a black hole exploring thingiverse ...

Pick up a few useful looking bits.

Thanks


> I ended up doing just this recently. Admittedly I was less worried about =
the
> space my usual 5 pin .1" Molex took up, and more concerned about the
> height. So I put the Molex in my board design. For my programming
> prototype board, I populated the connector. For all others I left the
> connector off. I made up a jig (3D printed, based on
> https://www.thingiverse.com/thing:33106 ) with a holder for pogo pins (Al=
so
> printed, based on this: https://www.thingiverse.com/thing:22688
> ).
>=20
> Worked well. Getting it on and off without bending the pins took a bit of
> practice and a couple of revisions to make it easier. I used pins that ha=
d a
> head wider than the pin size of the Molex so they just rest in the tinned
> holes where the connector would be.



--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.