> > I'm looking for a way, hopefully not too complicated, to gate signals
> > on and off without inducing more than maybe 100nV of disturbance.
> > The signals may be at ground, or may be riding on a volt or two.
> > "off" means more than 30dB reduction.
> >
> > Any ideas?
>=20
> Some of the better commercial analog switches have a charge injection of =
<
> 1pC.
>=20
> To get a 100nV of disturbance implies a load capacitance of 5-10uF.
>=20
> So if your source impedance is 1K you'd have a bandwidth of maybe 30Hz,
> which might be limiting.

I suspect that to get such a low injection voltage will require a shaped dr=
ive to the FETs to minimize any gate capacitance charge feedthrough. I woul=
d also be looking at series/shunt/series FETs to get the isolation.

But from a previous post it sounds like the object is to do transmit/receiv=
e switching (Ham bands were mentioned), in which case I would have thought =
there could be a way of pulsing the AGC momentarily to desensitise the rece=
iver. But if two series FETs are used with a shunt one, and the series ones=
 have their sources joined, the shunt one could be turned off microseconds =
after the series ones are turned on, thereby leaving a low impedance path f=
or any feedthrough to be shunted to ground (I'm assuming the object of the =
question is to isolate the receiver from the transmitter power when transmi=
tting).

--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.