We have these at the local jaycar in New Zealand http://www.jaycar.co.nz/Electromechanical-Components/Switches/Toggle/DPDT-M= iniature-Toggle-Switch---Vertical-R-A/p/ST0365 On 28 May 2015 at 01:12, Denny Esterline wrote: > C&K makes the ET25MD1AVBE, Mouser has about 50 in stock, but I think the > current rating is too low for you, at least with gold contacts, others ma= y > be available. > or the 7205SYAV2GE. Mouser has about 40, but the price is near $20 each..= .. > But I believe it ticks off all your categories, except it has a threaded > bushing... > > Much would depend on your needed quantities and lead time. With C&K, I us= e > about 1000/yr of some switches that fall in this category (in the catalog= , > but nobody really makes). Then we had it customized with wire leads and a > connector. Pricing is "pretty good", but minimum order quantities and lea= d > time are a bit hard to swallow. It took about three months and a $5000 > initial order to get them to get off their butts and do what I needed. > > You may also want to consider more "out of the box" ideas. Can you panel > mount the switch and run wires to it? Could you right angle mount a small > daughter board to hold a strait switch? (not right angle) Somebody else > already mentioned using a different switch function and using it to contr= ol > a different pass element (relays, FETs, etc) > > -Denny > -- > http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist --=20 http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .