I  have it working,
LOTs of lessons learned.
E.G. I send RST,
it replies with OK
AND 1.5 SECONDS later it actually is reset!
and it sends the reset message.
(I assumed it was in response to my later commands.)

Now I have to clean up my code segments....

Thanks for your support.

Tom

On May 19, 2015, at 5:05 AM, Wouter van Ooijen wrote:

> Thomas Sefranek schreef op 18-May-15 om 11:42 PM:
>> (Initializing the WiFi)
>> AT
>> OK
>>=20
>> AT+RST
>> OK
>>=20
>> AT+CWMODE=3D3
>> OK
>>=20
>> AT+RST
>> OK
>>=20
>> AT+CWJAP?
>> No AP
>>=20
>> (now the problem...)
>> AT+CWLAP
>> ets Jan  8 2013,rst cause:4,boot mode:(3,7).
>>=20
>> (It gives this message if I request a router connection.)
>>=20
>>=20
>=20
> Power supply to feeble? When the real WiFi work starts, the module will=20
> start to draw significant current.
>=20
> I had the same problem with a RaPi and a (supposedly) 1A supply.
>=20
> Wouter van Ooijen
> --=20
> http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist

  *
  |  __O    Thomas C. Sefranek  wa1rhp@comcast.net
  |_-\<,_   Amateur Radio Operator: WA1RHP
  (*)/ (*)  Motorcycle mobile on 145.41 MHz.

ARRL Instructor, Technical Specialist, VE Contact.

http://www.harvardrepeater.org

--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.