Hi Nathan,

On 19/03/2015 13:56, Nathan House wrote:
> Good morning!
>
> Schematic:
"Raw", for me, is a bad name for the "Vin" pin :-)

> Screenshots:
>
> https://www.foxytronics.com/misc/engr495/screenshots/1%20top%20poly.png
- pin LVP is not connected, I would not use it in this case
- I have not Altium so I can not check the sizes. If you must hand solder t=
he
board check that the pad be the larger possible.
- you are using a very small spacing between track and pad, have you checke=
d
that it's okay with your manifacturing process?
- I'm a little uncomfortable with the two vias under the quartz

> https://www.foxytronics.com/misc/engr495/screenshots/2%20bottom%20poly.pn=
g
- you have some tracks that are splitting in two the ground plane.

Good job!
     N

--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.