You could also use the UV tubes that are in the equipment for nail polish c= uring. Ebay has tons of them for less than $10 per tube. Jean-Paul AC9GH On Nov 1, 2014, at 3:57 PM, Denny Esterline wrote: > Some time ago (years now) I faced a similar question when I needed to wor= k > on an old project with some UV erasable parts. LEDs certainly couldn't do > it then, and I don't think they can today. Other options included small g= as > tubes sold for germicidal use. An exhaustive 12.5 seconds of googoling > finds these: > http://www.amazon.com/Verilux-CleanWave-VH01WW4-UV-C-Sanitizing/dp/B0018A= 330K > http://en.wikipedia.org/wiki/Ultraviolet_germicidal_irradiation > Which at least suggests things are still readily available. > Not that anybody cares, but my story ended by forcing the hardware upgrad= e > to a flash part so this became a non-issue. >=20 > Of course, you may be in the opposite situation - could you use an old UV > chip eraser? >=20 > -Denny >=20 >=20 > On Sat, Nov 1, 2014 at 12:18 PM, NOPE9 YES wrote: >=20 >> I would like to cure UV epoxy and do some UV experiments. >> ( Yes, I know I must shield my eyes ) >> I think I can get UVA,B,C from a continuos spark. >> A spark is not very convenient. >> I have not found any LEDs that are suitable. >> Gus in Denver >> -- >> http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive >> View/change your membership options at >> http://mailman.mit.edu/mailman/listinfo/piclist >>=20 > --=20 > http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist --=20 http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .