All,

 I have been trying to control a Graphics LCD that uses the Toshiba 6963
 controller chip.
 I have gotten it to display text and graphics. however I have run into
 an issue that I can't seem to figure out.=20

 What I'm seeing is I can't write text past column 12 in row 8. The LCD
 I'm using is a 240 x 64.
 I have it configured as 30 chars per row, and 8 rows. I have rows 1
 through 7 displaying text.
 For place holders in an array that I am using to hold the text, in the
 first two positions on each row, I have an "L", along with the row
number (1 through 8).=20
 At the end of each row, I have "END" along with the row number (1
through 8). This is true=20
 on all rows except row 8.   On row 8, I can't write past column 12. If
I try I get nothing=20
 on the display, and the port pins
 act as if the unit is resetting, or drawing too much current and
 causing the pins to cycle through=20
 on and off cycles. If I put the line position back to 12 (0x0C) or
 less, all is well.

 Also, if I change the OSCON register to anything other than what it is
 currently, it does the same=20
 thing. I have been working on this too long to be objective. Does
 anyone have any ideas what might=20
 be happening?

 I am open to any suggestions, and I would appreciate any insight anyone
 might have.

 I am using the 16F887 for this project, I am writing the firmware in
 assembler, and I am using the=20
 EASY PIC 6 development board from Mikroelektronika to develop the
 application.=20

 Please advise.

 Thanks and Regards,

 Jim

--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.