Jan-Erik,
     I'm sorry but I still don't get it. What do I put in where it says=20
'Enter your code here'?
Again I'm sorry,
rich!

On 7/19/2014 1:58 PM, Jan-Erik Soderholm wrote:
> This is of course a question for the list as a whole... :-)
>
> But, you put that anywhare in your C source just as you
> would do with any other C function definition.
>
> A short cut down example from a working code
> using a Timer0 interrupt:
>
> ------------------------------------------------
> // CONFIG1
> ...
> // CONFIG2
> #pragma config WRT =3D OFF
> ...
>
> #include <xc.h>
>
> void interrupt myint (void) {
>       if (TMR0IE && TMR0IF) {
>           TMR0IF =3D 0;
> ...
> ...
>           return;
>       }
> }
>
> void init(void){
> ...
> ...
> // Setup of ports, timers, interrupts and so on.
>       return;
> }
>
> void main(void) {
>       init();
>       ei();
>       while (1) {}
>    }
> ------------------------------------------------
>
>
>
> Richard R. Pope wrote 2014-07-19 20:27:
>> Jan-Erik,
>>        I forgot something. Now that it compiles with no errors and just
>> the warning that the paid for version will make smaller code how do I
>> use the interrupt code? I.E. Where do I put this:
>>
>> void Interrupt(){
>>        if (PIR1bits.TMR1IF){
>>          PIR1bits.TMR1IF =3D 0;
>>          TMR1H     =3D 0x0B;
>>          TMR1L     =3D 0xDC;
>>          //Enter your code here
>>        }
>> }
>>
>> Thanks,
>> rich!
>>
>> On 7/19/2014 1:10 PM, Jan-Erik Soderholm wrote:
>>> Either:
>>>
>>> PIR1bits.TMR1IF =3D 0;
>>>
>>> or simply:
>>>
>>> TMR1IF =3D 0;
>>>
>>> The bit struct definition is on the register
>>> level (PIR1), not on the bit level (TMR1IF).
>>>
>>> Jan-Erik.
>>>
>>>
>>>
>>>
>>> Richard R. Pope wrote 2014-07-19 19:40:
>>>> Allan,
>>>>          I'm using the MicroChip XC8 compiler. I just looked through t=
he
>>>> macros in the pic16f684 include file and the code should work. Would y=
ou
>>>> please take a look at this code section? The values that are being
>>>> flagged are the TMR1IF_bit and TMR1IE_bit definitions. Here is the cod=
e
>>>> with the flagged sections commented out:
>>>>
>>>> void InitTimer1(){
>>>>        T1CON     =3D 0x31;
>>>>        PIR1bits.TMR1IF =3D 0;
>>>>        TMR1H     =3D 0x0B;
>>>>        TMR1L     =3D 0xDC;
>>>>        TMR1IE     =3D 1;
>>>>        INTCON     =3D 0xC0;
>>>> }
>>>>
>>>>           I can't see what is wrong as these definitions are in the in=
clude
>>>> file. With these statements commented out the code compiles.
>>>> Thanks,
>>>> rich!
>>>>

--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.