Hello all,
     I just had a thought. Oh, what a dangerous thing. Oh well here it=20
is. What if I pull the output pins low with a 10K resistor hooked up to=20
ground and leave them in input mode. When I want to output a high I then=20
change the pin from input mode to output mode. I have already setup the=20
pin to output a high. So I am only changing the TRIS bit for the pin and=20
since the pins are only high for a very short period of time this would=20
minimize the current draw. This would only be 0.5mA of current. Am I=20
thinking clearly on this? What about using a 100K resistor?
Thanks,
rich!

--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.