Hi Guys,
Until now when I need to replace a device on a pcb I just scrape the
lacquer away with a small knife, but that always leaves me a bit uneasy...
I am finding that I am doing this more and more and would like to find a
better solution. Ideally I am looking for some chemical that will
remove/dissolve the lacquer without damaging anything else around it,
including the chip I need to remove and that will not compromise the
soldering of the new device once the fauty device is removed.
Any info/experience would be welcomed.
Thank you.
Best Regards
                 Luis
--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.