For PICs with more than one ICSP interface (PGC/PGD pair), you can use any =
one=20
for programming without any special setting or configuration (except for th=
e=20
switch on your board).

For debugging, you must make the correct setting for ICESEL in one of the=20
device configuration words. See Special Features section in the datasheet.

And by the way, do not clear the DEBUG bit(s) in the configuration words, t=
he=20
debugger tool does that for you automatically.

/Ruben


> I have the Microstick II and have been using it quite successfully.
>=20
> However, there is one thing I can't figure out - the little switch on
> the side. The schematic shows it selects either PGEDA/PGECA or
> PGEDB/PGECB as the load/debug interface.
>=20
> If I switch to the "D" interface, the programmer can't talk to the chip.
>=20
> I wanted to use the RB0 and Rb1 ports (which are also PGEDA/PGECA pins)
> for something else.
>=20
> Thoughts?
> --=20
> Larry Bradley =20
> Orleans (Ottawa) Canada=20

--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.