Try 'exit'

Sent from my phone

On Apr 19, 2014, at 10:59, Martin K <martin@nnytech.net> wrote:

> I'm working on an application that has an RN-131G (Roving Networks ->=20
> Microchip) module
>=20
> It was working decently fine, however it is always powering up in it's=20
> AP configuration mode now. It starts an access point with name WiFly GX=20
> ... which I can connect to with my laptop and see a command interface, et=
c.
>=20
> This is not the intended operation. My desire is to get back to the raw=20
> configuration mode wherein I can send it commands over the serial port.=20
> The manual indicates that GPIO9 high will force it to go into the AP=20
> config mode. I'm not using this pin at all, so I tried tying it to=20
> ground. Despite power cycles, it always starts up in the AP config mode=20
> which puts out the following on the serial port:
>=20
> WiFly WebConfig v1.06 Apr 19 2013 11:48:44 on RN-131
> Mac Addr=3D00:06:66:21:79:5c
> *READY*
> AP mode as WiFly-GSX-5c on chan 1
> DCHP Server Init
> reboot
> ERR: ?-Cmd
>=20
> <WEB_APP-1.06> help
> ERR: ?-Cmd
>=20
> <WEB_APP-1.06>
>=20
>=20
>=20
> I can't find documentation indicating why it's doing this and how to get=
=20
> it out of this mode. Are there any WiFly gurus out there?
>=20
> Thanks,
> Martin K
>=20
> --=20
> http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.