I'm working on an application that has an RN-131G (Roving Networks ->=20
Microchip) module

It was working decently fine, however it is always powering up in it's=20
AP configuration mode now. It starts an access point with name WiFly GX=20
.... which I can connect to with my laptop and see a command interface, etc.

This is not the intended operation. My desire is to get back to the raw=20
configuration mode wherein I can send it commands over the serial port.=20
The manual indicates that GPIO9 high will force it to go into the AP=20
config mode. I'm not using this pin at all, so I tried tying it to=20
ground. Despite power cycles, it always starts up in the AP config mode=20
which puts out the following on the serial port:

WiFly WebConfig v1.06 Apr 19 2013 11:48:44 on RN-131
Mac Addr=3D00:06:66:21:79:5c
*READY*
AP mode as WiFly-GSX-5c on chan 1
DCHP Server Init
reboot
ERR: ?-Cmd

<WEB_APP-1.06> help
ERR: ?-Cmd

<WEB_APP-1.06>



I can't find documentation indicating why it's doing this and how to get=20
it out of this mode. Are there any WiFly gurus out there?

Thanks,
Martin K

--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.