I am running into a problem with my setup of a nRF24L01+ module.

I have a  system that has two modules, one that acts as the master and=20
another acting as a slave.  The master calculates some data and creates=20
a small message of 6 bytes and broadcasts it once every 5 seconds.  The=20
slave listens for a packet and displays the information on an LCD.

If I set the data rate to either 1 or 2Mbps the system operates as expected=
..
If I set the data rate to 250Kbps the master node OBSERVE_TX register is=20
incremented with each transmission.  The slave node appears to be happy=20
in that the data is correctly displayed but the masters "appears" to not=20
be receiving the ACK.  Replacing both modules did not have an effect.

I would like to operate at 250Kbps since I will be pushing the range=20
limits and the slower data rate will help.  By the way I am using the=20
nRF24L01+ with PA and LNA.

Has anyone run into this problem before?  Is there some other change=20
that I need to make when I operate at the 250Kbps data rate?

   Thanks
   -Phil-
--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.