Hi,

Have you tried programming the device using the Pickit3 through MPLAB?



I selected the PIC24FV32KA301 using the device selector and it definitely i=
s supported by the PicKit3, ICD3, PM3 and the realice.



Your pin connections are correct, (according to the datasheet/ICSP guide fo=
r the part).



Do you have another of the same processor you can try in case you have a du=
d chip?



Do you have another type of pic you can try to test your PicKit?



-Jim





On Fri 19/07/13  1:55 AM , Mitch hunrudpop@gmail.com sent:

> I just received my first PIC24FV32KA301 (20 pin DIP) today and I can't

> seemto get it programmed with my pickit 3. My pickit is connected to:

>=20

> MCLR -> pin 1

> Vdd -> pin 20

> Vss -> pin 19

> DAT -> pin 4

> CLK -> pin 5

> LVP -> none

>=20

> I also have a 10uF cap between pin 14 and ground

>=20

>=20

> But when I fire up pickit programmer application, it can't detect the

> device. I try to manually select the device, and it's not even listed

> inthe dropdown list.

>=20

> I downloaded the latest "PICkit3 Programmer Application and Scripting

> Toolv3.10" from

> http://www.microchip.com/stellent/idcplg?IdcService=3DSS_GET_PAGE

> &nodeId=3D1406&dDocName=3Den538340&redirects=3Dpickit3

> and updated the lastest PICkit3 OS, but it's still not there. What am I

> doing wrong?

>=20

> Thanks for any help/advice you can offer.

> --=20

>=20

> http://www.piclist.com/techref/piclist PIC/SX

> FAQ & list archiveView/change your membership options at

> http://mailman.mit.edu/mailman/listinfo/piclist

>=20

>=20




--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.