Tinkering with mTouch once again, using the mTouch demo kit, and I've =20
chosen to start experimenting with the 16F1937 CVD board.  Fine it =20
works out of the box.

Now I want to tinker with the default firmware and verify that I have =20
the IDE/environment working before I start learning about the mTouch =20
API, etc., but I'm a bit confused.

I installed the MAL, and found the demos, but could not find the one =20
specific to my board revision (02-02091-R5) though they make it a =20
point to say that I need to match the code files to the board revision =20
I have.

So a few questions...
- Where would I find the R5 files?  My MAL is 2013-02-15, so fairly =20
new (and the mTouch kit is from mid last year).
- Should it matter if I use R3 files?
- How do I compile this?  I created a new project with MPLAB 8.66, =20
added all the .c files, but it does not recognize several of the =20
SFR's.  I'm using the HiTech C compiler but not familiar with it.

I found these few docs, but none seem to tell me how to compile the =20
default firmware, or something is not working correctly.  Is there =20
some doc I'm missing...
      - http://ww1.microchip.com/downloads/en/DeviceDoc/41385F.pdf
      - mTouchCap Library Help.pdf in the ...\Microchip\Help\ directory.
      - mTouch Framework Documentation.html

Cheers,
-Neil.


--=20
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.