I recall help on a doubt on programming some new chips (mainly
dspic33/pic32) wich they have 3 different PGC/PGD pin pairs.

I know that to debug in a different pins (EMU pins) than default ones I
need to first change Config registers. But what happens with programming
pins? Can I directly program a chip with any of those pairs without
changing anything? I mean, can I program a chip through pins PGEC2/PGED2
and another chip through pins PGEC3/PGED3 directly without any
configuration or do I need to first use PGEC/PGED default pins to change
"any register" and then proceed with other pins?

I do not have any board ready to try this at the moment and I'm dessigning
some one wich will save me some routing time and components (jumpers) if
that is possible. So any help is apreciated. I have readed and searched for
info on this, but have not discovered the answer to my question.
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.