You mean a thin layer of some other sheeting? Avoiding that too. Epoxy=20 is looking so tempting right now. On 10/23/2012 6:05 PM, Dave wrote: > That is usually handled using a sub panel and projecting the shafts thru = the front panel. > > Neil wrote: > >> Hi all, >> >> Can anyone recommend a panel-mount potentiometer that I can use on 1/4" >> thick wood? Most of the ones I'm finding seem to have 5mm - 6.5mm >> threaded sections, and factoring in the thickness of the nut and washer, >> that leaves a max panel thickness of only ~0.080". Ideal would be to >> avoid countersinking, but if I need to it's fine. It's just that 0.080" >> is really think for MDF. Anywhere from 5k to 50k is fine, linear >> taper. I need ~30 of these, so lower cost preferred. >> >> Cheers, >> -Neil. >> >> --=20 >> http://www.piclist.com PIC/SX FAQ & list archive >> View/change your membership options at >> http://mailman.mit.edu/mailman/listinfo/piclist --=20 http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .