That is usually handled using a sub panel and projecting the shafts thru th=
e front panel.

Neil <picdude3@narwani.org> wrote:

>Hi all,
>
>Can anyone recommend a panel-mount potentiometer that I can use on 1/4"=20
>thick wood?  Most of the ones I'm finding seem to have 5mm - 6.5mm=20
>threaded sections, and factoring in the thickness of the nut and washer,=20
>that leaves a max panel thickness of only ~0.080". Ideal would be to=20
>avoid countersinking, but if I need to it's fine. It's just that 0.080"=20
>is really think for MDF.  Anywhere from 5k to 50k is fine, linear=20
>taper.  I need ~30 of these, so lower cost preferred.
>
>Cheers,
>-Neil.
>
>--=20
>http://www.piclist.com PIC/SX FAQ & list archive
>View/change your membership options at
>http://mailman.mit.edu/mailman/listinfo/piclist

--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.