Hi folks,

I have a piece-of-cake question for the most of you ;

For some test purposes I am trying to implement some stuff in a
18f452. By referring to datasheet (39564c.pdf ~ 5.7Mb) I think I am
not able to set the correct bits right. For the initial test I tried
to use the built-in function of the C18 compiler, my other routines
work perfectly well except the lousy internal ADC. For the test ;


#include <adc.h>
#include <stdlib.h>
#include <delays.h>

unsigned int result;

void main( void )
{
TRISA =3D 1 ;
TRISB =3D 0;
LATBbits.LATB6 =3D 0;

OpenADC( ADC_FOSC_32 & ADC_RIGHT_JUST & ADC_8ANA & ADC_CH1 & ADC_INT_OFF );
Delay10TCYx( 5 );

ConvertADC();

while( BusyADC() ){
    result =3D ReadADC();
    if(result<=3D512){
        LATBbits.LATB6 =3D 1;
        Delay10TCYx( 5 );}
}
}

Internal ADC of this device is 10bits thus should provide a value
between 0-1023. Threshold is chosen exactly in the middle thus I can
check if the routine works by applying 0V and 5V to AN0. The problem
is ; it doesn't work (chinn chinn). I succeded following the same
methodology at other devices from Microchip but no luck with the
18f452. I think it's an older device thus the datasheet I mentioned
above might be incompatible at a point or more with latest versions of
C18 and MpLabX.

Exact error when compiling this unbelievable short code is ;

too few arguments in function call

in the OpenADC function.

When checked out the C18 documents, it is clearly stated that these
configurations for OpenADC should suffice.

I wanted to have opinions that can save me some time before I believe
this thing worth digging deeper.

Have a nice day.
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.