> Check the requirements of the RS232.  You might want to consider the
> case where one unit is running at +5% and the other at -5% (if both ends
> are the same unit).  The baud rate accuracy requirement increases with
> baud rate, IIRC.

Common misconception! Apart from minor influences like the switching=20
time of the hardware the accuracy requirement for asynch does NOT depend=20
on the baudrate. Hence you can not escape the accuray requirement by=20
running at a lower baudrate.

Wouter van Ooijen
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.