Interesting stuff for building tiny gizmos! Definitly bookmarked. Thanks On Thu, Sep 6, 2012 at 3:41 AM, Jake Anderson wrote: > nope way too big. > I found some though > > http://www.gizmoszone.com/shopping/agora.cgi?product=3DOther_gear&user4= =3DMiter_gear;ppinc=3D1a > > the same place I got the motor from (duh) but i lost their website until > now lol. > > Thanks anyway ;-> > > On 05/09/12 19:02, Matt Callow wrote: > > smallparts.com.au have 8mm OD with 3mm shaft. Is that any good? > > > > > http://www.smallparts.com.au/store/partslist/gearsmitremodule05/gearsmitr= emodule05/wide/1/ > > > > Matt > > > > On 5 September 2012 14:08, Jake Anderson wrote: > >> I'm after some tiny bevel/miter gears for a right angle gear system. > >> By tiny i mean 6mm or so OD. > >> Preferably with a 1.5mm shaft size. > >> > >> I've scoured the usual places and nobody seems to do anything much > >> smaller than 12mm. > >> Does anybody have any ideas where I could go to find them? > >> quantity is up to 200 but I want 4 or so to test with. > >> load is pretty minimal, plastic would probably do but I'd prefer brass > >> or better. > >> > >> -- > >> http://www.piclist.com PIC/SX FAQ & list archive > >> View/change your membership options at > >> http://mailman.mit.edu/mailman/listinfo/piclist > > -- > http://www.piclist.com PIC/SX FAQ & list archive > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist > --=20 Perry Curling-Hope Research and Development --=20 http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .