Do you know anyone with a 3D printer that could run a batch of housings for= you? RP On 4 September 2012 15:45, Neil wrote: > ...specifically a small unit with 2 momentary switches, but something > "finished" that an end-user can stick on a dash or center console. So > far I've made a few of these with a small PCB, a couple of tact > switches, and a machined plastic housing, but it's very time-consuming > to make the housings. I need about 50-100 of these, and really dreading > the thought of machining all of these housings, so hoping to find > something commercial. > > I'm picturing something like a thin membrane switch or one of those > small remote controls (but wired). Even if I can find something that > was originally intended for another product, I can put a new label on > it. I remember something very similar on the outside of a toy box some > years ago and it had the switch panel stuck outside the box with "try > me" on it. When opened, the switch unplugged from the toy and thrown awa= y. > > If I found 2 individual switches that could be neatly stuck together or > screwed together, that would work. Any leads? > > Thanks, > -Neil. > > > -- > http://www.piclist.com PIC/SX FAQ & list archive > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist --=20 http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .