David to make it clear this is the one,=20
http://www.rapidonline.com/Tools-Equipment/Automatic-wire-stripper-CK-78216=
,
that I think is very good. All of my techs like it over anything else.  Be=
=20
careful of cheep Chinese nock offs.  I bought a pair
that were yellow and were no good.  When I looked at them real good they=20
were not made like the red pairs I have but
looked like them in general.

Derward



----- Original Message -----=20
From: "Nily" <seoane_re@sinectis.com.ar>
To: "Microcontroller discussion list - Public." <piclist@mit.edu>
Sent: Thursday, August 23, 2012 6:50 PM
Subject: RE: [EE] Automatic wire strippers


http://www.rapidonline.com/Tools-Equipment/Automatic-wire-stripper-178176
(haven't
used this particular brand but appears to be 'the same').

If you can buy anything else, don't buy this one. I can't say this brand is
good or not, buy similar strippers are from China and work for a while and
one day, under normal use, they don't do any more.

-----Mensaje original-----
De: piclist-bounces@mit.edu [mailto:piclist-bounces@mit.edu]En nombre de
Derward Myrick
Enviado el: Jueves, 23 de Agosto de 2012 04:14 p.m.
Para: Microcontroller discussion list - Public.
Asunto: Re: [EE] Automatic wire strippers


David this one is the best I ever used.  Other than the $5,000 one that I
have
that is an automatic stripper and cuter that takes a roll of wire and cuts
to length
and strips both ends.  You just key in haw many and length plus the strip o=
f
each
end.






                                http://www.rapidonline.com/Tools-Equipment/=
A
utomatic-wire-stripper-CK-78216

Derward KD5WWI






----- Original Message -----
From: "David" <lists@edeca.net>
To: <piclist@mit.edu>
Sent: Thursday, August 23, 2012 4:25 PM
Subject: [EE] Automatic wire strippers


Has anybody got opinions on "automatic" wire strippers such as those
linked below?  Are they recommended or just gimmicks?

Until now I have been using a very old pair of strippers which have a
screw/nut to adjust the width.  This is annoying as it is quite hard to
set accurately.

I am mostly stripping stranded & unstranded thin wire for PCB assembly
and prototyping, but also thicker wire from power supplies etc.  Happy
to pay a bit more than =A32.50 for a pair of wire strippers that work.

http://www.rapidonline.com/Tools-Equipment/Weicon-Professional-Wire-Strippe=
r
-No-5-86-0320/


David
--
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist


--
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist

--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist


--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.