There are multiple emud and emuc on that device so you can use the
alternate ones.


Chetan Bhargava


On Fri, Aug 3, 2012 at 2:39 PM, Herbert Graf <hkgraf@gmail.com> wrote:
> Hello all,
>
> stupid question, but how do I use the EMUD/EMUC pins for debug?
>
> I have a dsPIC30F3013 on a board. I've connected a Pickit3 to it and can
> successfully program it and debug it using PGD/PGC.
>
> I'm using MPLABX. Unfortunately, for my application I can't use the
> PGC/PGD pins for debug since I need to use the I2C block on this part.
>
> So, I've enabled EMUD2/EMUC2 in the config settings. I can't seem to
> figure out how to get MPLABX to seperate the build/program/debug stages.
> I need to since to program I have the Pickit3 plugged into the PGD/PGC
> pins, and then for debug I have to plug into the other pins.
>
> I've done some searching and I'm going over the Pickit3 and MPLABX
> manuals, but so far nothing is catching my eye.
>
> I hope someone here can point me to how to do this?
>
> Thanks, TTYL
>
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.