Hello all,

stupid question, but how do I use the EMUD/EMUC pins for debug?

I have a dsPIC30F3013 on a board. I've connected a Pickit3 to it and can
successfully program it and debug it using PGD/PGC.

I'm using MPLABX. Unfortunately, for my application I can't use the
PGC/PGD pins for debug since I need to use the I2C block on this part.

So, I've enabled EMUD2/EMUC2 in the config settings. I can't seem to
figure out how to get MPLABX to seperate the build/program/debug stages.
I need to since to program I have the Pickit3 plugged into the PGD/PGC
pins, and then for debug I have to plug into the other pins.

I've done some searching and I'm going over the Pickit3 and MPLABX
manuals, but so far nothing is catching my eye.

I hope someone here can point me to how to do this?=20

Thanks, TTYL

--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.