What about:
0010 =3D Compare mode, toggle output on match (CCP1IF bit is set)
>From page 127 of 41262E.pdf

Matt

On 3 August 2012 20:46, Jan-Erik Soderholm <jan-erik.soderholm@telia.com> w=
rote:
> Hi.
>
> Checked datasheet for 12F683 and 16F690.
>
> In the CCP section, "Compare mode", it says :
>
> When a match occurs, the CCP1 module may:
> - Toggle the CCP1 output.      <<<=3D=3D=3D  Note!
> - Set the CCP1 output.
> - Clear the CCP1 output.
> ...
> The action on the pin is based on the value of the
> CCP1M<3:0> control bits of the CCP1CON register.
>
>
> Now, the table for the CCP1CON register says :
>
> 1000 =3D Compare mode, set output on match (CCP1IF bit is set)
> 1001 =3D Compare mode, clear output on match (CCP1IF bit is set)
>
> There is no "toggle output on match" option there
>
> Is this a (known) datasheet error?
> There is nothing in the errata documents.
>
> Jan-Erik.
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.