I don't know of a vendor that works with small quantities, prompt and cheap=
!
Since I have no personal experience with ordering to spec I cannot make=20
a recommendation.

I have been dabbling with toner transfer DIY boards lately and I still=20
have a lot to learn. Even when you have etched a board there is much to=20
be done. Few DIY processes provide plated through holes, alignment for=20
double sided is difficult (for me) and drilling 40 or more tiny holes=20
accurately gets old quick.

Manufacture of PC boards seems to be a commodity process. A substandard=20
product is useless and the cost of doing business at the required=20
precision is high. The risks are high due to the cost and availability=20
of supplies.

There is a lot of information in the PICLIST archives and elsewhere on=20
the net.

On 7/11/2012 11:34 AM, Jason White wrote:
> Thanks Everyone !
>
>> I always figure a good commercial manufactured special purpose PC board
>> (double sided) is a bargain at $15.
>> It takes a bit of bad experience to reach that value!
>>
>> Good luck!
> What company offers these ? Though my problem is that most cheap
> places have horrific lead times.
>
>

--=20
John Ferrell W8CCW
=93During times of universal deceit,
   Telling the TRUTH becomes a revolutionary act=94
      George Orwell




--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.