On Wed, Jun 20, 2012 at 3:26 PM, Mark Hanchey wrot= e: > On 6/20/2012 5:32 PM, AK wrote: >> You would need a very high power laser to enable scanning that fast, >> and a very high speed, high power driver. Plus the plastic lenses in >> those units would just melt. Not the right assembly for the job. >> =A0 =A0Why not just print stencils with something like this >> http://www.amazon.com/Cricut-29-0001-Personal-Electronic-Cutting/dp/B000= W5I9OC >> lay them on the work and spray a light coating of varnish or stain >> overtop on the wood > > The time it takes doesn't matter to me, it can take hours and I wouldn't > mind, it is also the fun of doing the project and getting it all to work > . Those cricut machines will not work for what I do, the patterns are > custom designs and the cricut machines can't do large patterns or use > your own designs. Argh, I was about to reply to say that you can get third party software that works with the Cricut, but found out that due to a lawsuit it is no longer available. :( --=20 http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .