Hi Jack,

That kit comes with one populated board and two blank boards.

There is no RJ-11 connector, nor is there a place for it. It has a 0.1"
header to mate with a PicKit 2 or 3.

The 16F886 supports in-circuit debugging so you don't need an ICD
header, but you will need an adapter cable if you use an ICD instead of
a PicKit.

Cheers,

Bob


On Fri, Dec 9, 2011, at 02:02 PM, John Gardner wrote:
> Are the ICD Header & RJ-11 to ICSP adapter required for
> In-Circuit debugging with this board (which comes with a
> 16F886 installed) ? The docs are a bit confusing...

--=20
http://www.fastmail.fm - Email service worth paying for. Try it for free

--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.