Hi all,

I'm planning on using standard unshielded (for now) Cat5/5e patch =20
cables to run I2C signals and power between 2 boxes, over a length =20
~15ft.  Looking for thoughts on how best to organize the wires in the =20
cable to minimize noise effects.  Of the 8 conductors, 2 will be =20
power, 2 ground, one SDA, one SCL, one other signal.

Since these are set up as 4 pair(s), would it make a difference if I =20
run the SDA/SCL signals on one pair, or should I split up the SDA with =20
one ground, SCL with another, etc?

Cheers,
-Neil.


--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.