Thanks

	org		0f000h
	dt 		b'00001111'

Works... on a 16F18xx its not an F19xx so there is a little inconsistency
there...=20

This isn't what the help file on MPlab says...


Thanks
Steve

-----Original Message-----
From: piclist-bounces@mit.edu [mailto:piclist-bounces@mit.edu] On Behalf Of
Djula Djarmati
Sent: 28 September 2011 21:55
To: Microcontroller discussion list - Public.
Subject: Re: [PIC] PIC16F1827 EE declaration in code.

On 28-Sep-11 22:12, Steve Smith wrote:
>
> This is a silly thing I have run out of ideas on....
>
> Th define EE contents in code I have always used the following
>
> org 0x2100				; address 0 of ee
> dt	0f0h,0fh,b'01010101' 	; F0,0F,55... ect
>
> For some reason on this chip when using abs code it fails with this
error:-
>
> Error - section '.org_3' can not fit the absolute section. Section
'.org_3'
> start=3D0x00002100, length=3D0x00000002


 From MPASM Assembler Help:

EEPROM Start Address by Device
Most PIC1X MCUs: 0x2100
PIC18 MCUs:      0xF00000
PIC16F19XX MCUs: 0xF000

Try 0xf000.

Djula


>
>
>> From the help I know that the base address is right and it doesn't fail
> until the dt is line is compiled. I have used the same code for years on
> '877 ect and these don't fail.
>
> Thanks
>
> Steve
>
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist

--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.